Search results

If your sure thats the spot, drill a hole in the plug, it will be about a 1/8-1/4" thick, than there is some room, next is your fuel screw...so don't drill too deep. Once you have your hole in there you should be able to pull it out, that's what I do on my motorcycles which all get dynojets...

Spark n' all is good, jets are two sizes up, figure because of the FMF pipe. So I cleaned the carb out again and turned out that the float needle was all gum'ed up, didnt take it off in first cleaning as it looked 'good' on the surface but when I took of the float and pulled that needle out it...

I bought a 2001, cleaned it up this weekend, started it, same thing, idles high (normal if you have choke on or check if tension is too high on throttle cable if its bad), exhaust header got hot within like 30 seconds and than made a popping noise around intake boot, sputtered and died. Same...

by some miracle I found it...it actually got stuck between the floats, it sits flush with the carb body :) still couldn't get it to run w/o carb spray...its getting the fuel but just wont start..back to the drawing board...compression @ 130 three cranks cycles and 145 on 5 crank cycles, that...

Hi Guys, I cleaned up the carb of my ebay purchase yesterday and accidently blew off the washer on the carb. Now I know I'll never (ever) find that thing again in the mess of my garage and it will take 3-4 days to get my order from RMA in the mail, but does anyone know what the thickness of...

Hi Guys, thought I'd introduce myself quickly. I'm from Maryland and have quite a motorcycle history but never managed to get on an ATV until a week ago, so now I'm hooked and bought a Warrior 350 off eBay (uh boy...lesson learned) Can't wait to get it running and do a donut on our lawn...