Tusk heel guards for Warrior
- Thread starter bmx71
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
missouritrailrider
Well-Known Member
- Joined
- Sep 11, 2007
- Messages
- 1,127
- Reaction score
- 0
z400 or ltr450, possibly raptor 660 or 350, prm makes rappy 350 ones for sure
DeadLastRacing
Well-Known Member
Z400 have been the most commonly used.
their all the same but remember they will need slight modification
98-warrior
Well-Known Member
could u put another pic up again and what all mods do you need.
it wont show the pic
it wont show the pic
dbkid0486
Well-Known Member
- Joined
- Oct 27, 2010
- Messages
- 68
- Reaction score
- 0
whats the modification that needs to be done?
DeadLastRacing
Well-Known Member
Z400 heal guards on the warrior.
I run the yfz450 Pro Armour pro peg set up on mine. A little modding was need to make those work as well.
I run the yfz450 Pro Armour pro peg set up on mine. A little modding was need to make those work as well.
DeadLastRacing
Well-Known Member
I have no idea. Not my quad. As I stated I run a modded YFZ heel guard.
Looks to me like the rear side mounts are about an inch and a half above where the warrior ones mount. He doesn't appear to have them mounted. But also on this quad, he is running the IMS pegs, which would move the guard mounting location back by a stock warrior peg width.
Heres my heel guard post:
http://www.yfm350.com/forums/showthread.php?t=20958&highlight=pegs
Looks to me like the rear side mounts are about an inch and a half above where the warrior ones mount. He doesn't appear to have them mounted. But also on this quad, he is running the IMS pegs, which would move the guard mounting location back by a stock warrior peg width.
Heres my heel guard post:
http://www.yfm350.com/forums/showthread.php?t=20958&highlight=pegs
87warrior917
Well-Known Member
damn i like that look! but for my monster 97 i dont want nerf bars. those r IMS pegs huh thems r nice! does IMS make them for a warrior or r they for something else and modded to fit?
DeadLastRacing
Well-Known Member
I think at one time IMS did make them. I think with lack of sales they might have discontinued them. U might want to give them a call. When I was lookin I couldn't find much.
87warrior917
Well-Known Member
ah gotch ya. ill prog just make some like i did for my 87. but i do like them heel gaurds. and btw your peg/heelguards are the ****! :tup:
From the pictures it looks like you could just use some square tubing to fill the gap between the foot pegs and guard, if you don't want to mod the stock pegs. On my Raptor, the pegs are a little wider than the Warriors, so the gap shouldn't be quite as big. The rear bracket might be a little trickier though.
I might get a me a cheap, used set on Ebay to experiment with.
