dshiznit
Well-Known Member
I was thinkin of cuting the front plastic of my warrior and was just wondering if yall could post some pics of urs with the platic cut just to get some ideas.
Plastics...
- Thread starter dshiznit
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
98warrior
Well-Known Member
I've been thinking of cutting mine too, but it probably wont be till this spring.
warriorspeed350
Well-Known Member
mine
klutchbuster350
Well-Known Member
deadaim
Well-Known Member
dave76
Well-Known Member
Looks pretty cool.
warriorcliff77
Well-Known Member
Here's mine:
slamdam97
Well-Known Member
imtarnished
Well-Known Member
~Bill
dave76
Well-Known Member
Still not into fully cut fenders though.
dswwarrior350
Well-Known Member
i used a bigger grinder with a cutoff wheel made for metal... it takes skill to use that though haha... dremel will work. Then i used 220 grit to smooth them up after shaping them with the grinder. then went clear to a 2000 grit.
98warrior
Well-Known Member
Thats an awesome cut dsw, but ewww twist throttle
xj4m3
Well-Known Member
Here is my cut, i used an air saw. I also left some of the lower so i re-used the fender bracket and modified it to fit.
dswwarrior350
Well-Known Member
Yea i never liked the thumb throttle.. i had no control when riding anywhere but flat ground.. Every bump the throttle was doing all kind of things.
With the twist i have total control at all times.... everyone will disagree though... but i grew up on dirtbikes so it comes natural.
The edelbrock works better with the push/pull type throttle anyway.... its near impossible to ever have a stuck throttle.
warriorcliff77
Well-Known Member
Amen DSWwarrior350! Yer not alone in the twister club! I've put twisters on everything: from my Big Red250 to my Enticer340, my warrior's got one too.
