Hey, y'all I've got an 01 that has been resting for 5 years I started messing with the carb and the plunger snapped in the bowl now I'm thinking new carb can't figure what mm the mikuni is and where to go from here been looking but not sure any suggestions would help the bike is stock just want it to run like it used too but don't want to chance ebay!??
01 warrior carb
- Thread starter jcwarrior
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
fknboss
Well-Known Member
the Plunger for the accelerator pump? same thing happened to me. I just put the shaft back in the hole and put the boot back on to seal it up and put it back together. Mine runs absolutely fine don't see a difference at all no bogging or anything.. If you don't want it ill give you 20 bucks for it for a spare because apparently no one but me can get them to run right without an AP
THORrider05
Well-Known Member
The stock carb is a Mikuni BTM 36mm
