Hi guys hope u can help well here goes my 02 blue 350 warrior starts up and runs but sputters backfires like its lean until it warms up then its good. i thought it was a carb problem rebuilt carb and cleaned a bunch of times then i got a z400 carb rebuilt that bought brand new raptor intake manifold still runs the same way no change so i assume its not fuel related
now timing and valves are dead on stock exhaust and air box new piston and rings and gaskets and seals new ngk spark plug. now guys this is what i did i bought this 02 blue warrior 350 as a roller i have a 99 warrior 350 motor i put in i traced out the stator wires and pulser coil wires and soldered them in. like i said bike starts right up runs bad until it is totally warmed up i also did the clutch e-brake wire bypass. so my question is by using the early stator and flywheel from a 99 350 warrior in a 02 350 warrior would this cause my problem. let me know what u all think give me some input on this thanks in advance
Lou
now timing and valves are dead on stock exhaust and air box new piston and rings and gaskets and seals new ngk spark plug. now guys this is what i did i bought this 02 blue warrior 350 as a roller i have a 99 warrior 350 motor i put in i traced out the stator wires and pulser coil wires and soldered them in. like i said bike starts right up runs bad until it is totally warmed up i also did the clutch e-brake wire bypass. so my question is by using the early stator and flywheel from a 99 350 warrior in a 02 350 warrior would this cause my problem. let me know what u all think give me some input on this thanks in advance
Lou