97 warrior no spark

[kezzo713]

Bought a 97 warrior that doesn't run. I've changed stator assembly, cdi, and voltage regulator but I'm still getting no spark. Ignition coil is fine and carb is rebuilt also but there are 4 separate black wires that are cut and I'm not sure where they go, I really need help on getting this thing cranked any suggestions?

 

[kezzo713]

The starter also spins when pressing the start button and the lights work but the killswitch is stuck in the on position and two of the cut wires are to the killswitch

 

[hammy7734]

It could also be your flywheel key so take off that little plastic piece that is on the case near the stator cover


Sent from my iPhone using Tapatalk

 

[kezzo713]

It could also be your flywheel key so take off that little plastic piece that is on the case near the stator cover


Sent from my iPhone using Tapatalk

The cover that's after you take off the stator?

 

[hammy7734]

No there is a little plastic piece that unscrews from the case to check top dead center but take it off and turn the motor over to see if it spins


Sent from my iPhone using Tapatalk

 

[hammy7734]

Sent from my iPhone using Tapatalk

 

[kezzo713]

It spins but not fast

 

[kezzo713]

I also found out theres no compression

 

[hammy7734]

Well there could be another problem


Sent from my iPhone using Tapatalk