Camber issue

[97warrior_rider]

Ok so here goes I got a 97 warrior mainly stock minor mods here and there but stock front end.i was sitting on my tailgate the other day when I noticed my front end sitting kinda leaned figured it was the angle it was on came out later and the left front tire is actually pitched in at the base of the tire as if the none adjustable a arms were pulled in on bottom pushed out on top tire wear tells me there's an issue with the one side but don't know what it is any ideas

 

[alex456123]

Your spindle must be bent.

 

[97warrior_rider]

I thought that at first as well ill try to get a pic of both sides tommorrow after work I figured a measure ment between the gap on upper and lower ball joint would give me a better idea of if it was in fact bent but my luck turned out same distance between both sides any thoughts as to how I would find out if it was bent other then that

 

[lbjamm]

How's the a arm bushings?

 

[97warrior_rider]

No issues in bushings and ball joints were tight as well

 

[jeffsyfm350x]

Are your shock preloads adjusted the same in the front?

 

[97warrior_rider]

Yup completely maxed due to the fact that they are in need of replacing

 

[97warrior_rider]

I can honestly say I don't have the slightest idea as to what can be causing It

 

[jeffsyfm350x]

I can honestly say I don't have the slightest idea as to what can be causing It

Let off on preload and let your quad sit down lower it will change the look..

 

[alex456123]

Let off on preload and let your quad sit down lower it will change the look..

No that's not a shock issue... The camber toes in when it extends.

 

[jeffsyfm350x]

No that's not a shock issue... The camber toes in when it extends.

Actually I checked mine the camber pretty much stays the same unless stockers work different dont think they do so he must have something bent..

 

[alex456123]

Actually I checked mine the camber pretty much stays the same unless stockers work different dont think they do so he must have something bent..

Yup I'm thinking the same thing.

 

[97warrior_rider]

I'm sure something is I'm looking in to +2s so if it is bent that should take care of the issue like I said the spindle looks and measured fine but the a arms could be slightly bent and not be to noticeable

 

[jeffsyfm350x]

Go with some fullflights and you can't beat the price.

Sent from my BlackBerry 9310 using Tapatalk

 

[97warrior_rider]

That's what I've heard are they complete sets or needing things aren't they made in az as well

 

[lbjamm]

Full Flights are great arms. Plenty of adjust-ability and come with everything you need.

 

[97warrior_rider]

My step mothers cousins sponsored by lone star and if I remember right he did his a arms and had to buy new brake lines would I have to do the same if I'm doing the upgrade

 

[jeffsyfm350x]

That's what I've heard are they complete sets or needing things aren't they made in az as well

Yup there a complete set and there made in kentucky..

 

[97warrior_rider]

ok ill deffinitely look into a set for sure

 

[jeffsyfm350x]

ok ill deffinitely look into a set for sure

I have them on mine I like them a lot!