Corssing over bumpers

[r350ridin]

Well i love this bumper and thsi was the one that i was going to get until i found out it isnt made for the 350, is there another quad that has the same bolt pattern or similar? heres the bumper http://www.danacreechracing.com/categories/products/product-410.html

 

[boxhead]

Just get the damn AC bumper, almost the same damn thing and for less money probably. Why experiment and risk a damaged frame when you can have something almost the same that works with no fabrication required? The only difference is that it has a small level section rather that a v point on the top and doesn't have that star cutout in the mudscreen. There is another company that makes the same damn bumper also at magicracing.

 

[kreed5821]

Somebody lick the red off ya candy or something?

r350ridin, like Boxhead, I have no idea. Hope ya find out though. You might try contacting them to ask about it.

 

[pelphrey]

115 for a bumper. No thanks. I paid 50 shipped for my alba bumper. I see no reason to spend this kind of money on a bumper.

 

[r350ridin]

maybe because i want a unique bumper?? i dont like AC, and i really hate there nerfs.

 

[boxhead]

It's the same thing though, just with a different shape cut out of the mudscreen for the most part. Just get an AC and cut your own pattern in it and save the 40 bucks. Waste of money, especially when you have to fab it just to fit.

 

[r350ridin]

dont the 660 and 350 have the same front bumper?

 

[boxhead]

I doubt it, but I have no idea on this one. Companies usually tend to keep some measurements standard though. I wouldn't be surprised if so.

 

[kreed5821]

I can check on it for you this weekend. I'll compare mine to my little Bro's.

 

[r350ridin]

thanks alot kreed

 

[usdsk8er540]

i put a 400ex bumper on my 300ex and it wasnt too hard. just had to make some spacers for the bottom mounts and bolt it on with slightly longer (maybe 1/2 inch) bolts. as for the blingstar bumper, check the measurements on your frame for the bumper mounts, like distance between left and right sides for top and bottom, and distance from top and bottom mounts. write down (or draw) those measurements, then look at a different quad (like the 660 or yfz450) and take those measurements. if there isnt a whole lot of difference, you wouldnt even have to cut, maybe just bend some stuff around (the bumper, NOT the frame) or make spacers. dont be afraid to go to the local dealership and take some measurements on quads there. they shouldnt mind (unless they are dicks!). then proceed with caution and take your time. hope it works out for you and you arent out $115 if it doesnt work. i like that bumper better than the ac racing one as well, but im running the alba bumper and love it.

 

[r350ridin]

thanks usk8ter, i know some people cant justify spending that much on a bumper, but i like to be unique and i like blingstars stuff

 

[warriorguy5]

are the Raptor 350 bumpers the same as the warrior?



~Eddie

 

[usdsk8er540]

i dont think they are. havent tried before.

 

[warriorspeed350]

i 350 bimper wont fit on a 660, the 350 is alot wider and will need spacers but putting the 660 on the 350 there will be some serious bending involved