Extremely frustrating and confusing

[Np57]

Hello all. I rebuild the top end of my warrior. Brand new cylinder jug along with brand new cylinder head. I started it and it runs good. But here's the catch.. It leaks oil out of the cylinder jug gasget. The gasget that sits on the bottom end. I made sure all of my bolts are tight but it appears that it is seeping out. The gasket was brand new and un damaged. Does anyone know what's wrong?

 

[Warrior1996]

What brand gasket did you use?

 

[ag2560]

Did you put the O-Rings between the cylinder and the case?

 

[Np57]

I'm not sure I'll have to check. It was a good aftermarket one I'm pretty sure

 

[Np57]

Shot that might be it! I don't thing I did.. I didn't even know a no ring went there... Lol... Dumb mistake.... So what exactly goes there?

 

[Np57]

So there's a o ring that goes between the cylinder and the case?

 

[ag2560]

Yes there`s an O-Ring that goes around the big alignment pin with the oil passage.

 

[Np57]

Big alignment pin.... The outter sleeve do you mean?

 

[ag2560]

In this diagram the alignment pins are numbers 3 and 5. And around number 3 is the O-Ring number 4.
http://www.cheapcycleparts.com/oemparts/a/yam/50038c3ff870021f60a0b3db/cylinder

If you need some help or have other questions PM me I`ll give you my number to give me a call.

 

[Warrior1996]

In this diagram the alignment pins are numbers 3 and 5. And around number 3 is the O-Ring number 4.
http://www.cheapcycleparts.com/oemparts/a/yam/50038c3ff870021f60a0b3db/cylinder

If you need some help or have other questions PM me I`ll give you my number to give me a call.

He actually PM'd me yesterday and I gave him the same diagram and information.

 

[ag2560]

That`s what I like about this forum everybody helps everybody.

 

[Warrior1996]

That`s what I like about this forum everybody helps everybody.

Totally agree, this is one of the best forums around.

 

[Np57]

Thanks guys!