how to install kill switch and nerf bars?

[warriorrider13]

I was wondering how to install a tethered kill switch . Because in the spring in trying racing and that is one of the requirements.


Also , how are Nerf bars but on?it looks like they are welded but I have never seen any in real life soooo .

 

[yamaharaptor350]

nerfs bolt on there not very hard to put on... not sure about the kill switch, ive nver put one in

 

[yamarider]

kill switches are simple, just 2 wires to hook up. Different kill switches hook up different ways, but they all come with instructions

 

[warriorkid]

well, my kill switch didnt come with directions...Basically, there are two wires for the kill switch. One is the ground, so your scratch off a spot on the frame so it is just bare metal, tty to do it around a bolt hole, so u can just put the wire under the bolt, then tighten the bolt with the wire underit, so it is touching the bare metal. Then hook the posative wire to the coil.

 

[kreed5821]

Nerfs are simple. They come in three big pieces. One for each side and a connecting tube that goes through the frame. That's how my DGs are anyway. I suggest throwing away the bolts that come with it and going to the hardware to get some case hardened ones.

 

[06yfm350]

The hardest part to putting nerfs on is the netting if they didn't come pre-netted.. took me like 45 mins to get the netting done in my DG's lol.. use a flat head screwdriver to help you with the nets.. worked for me..