Is something Bent?

[deerman2701]

I just installed new wheel bearings and new brake pads and now the pads rub against to rotor very badly.

it never used to do this before the install of the new parts.

what could this be? its only on the one side. and i installed both sides exatcly the same and even tore into the wheel and caliper and everything like 4 times and found nothing!

http://www.youtube.com/watch?v=4heapSKEz0Y

any ideas would help greatly this is the only thing holding me back from riding!

 

[DeadLastRacing]

I wouldn't let that hold you up. After your first ride that bit of pad that's getting caught up will burn off. Its not much because the wheel spins slightly. I'm guessing a bent disk.

 

[deerman2701]

okay sweet thanks gonna test it out tomorrow at least for a little bit ..


it needs to be summer time im tired of this cold weather!

 

[brett1994warrior]

okay sweet thanks gonna test it out tomorrow at least for a little bit ..


it needs to be summer time im tired of this cold weather!

You stole the words right out of my mouth. A little winter is ok but enough is enough!!!!

 

[87warrior917]

okay sweet thanks gonna test it out tomorrow at least for a little bit ..


it needs to be summer time im tired of this cold weather!

It needs to snow more!!!! I love it. Nothings better than the tips of your fingers frezzing in 20 mins of riding lol

 

[MotoArts]

I posted this in the other thread... If one side spins fine, swap the HUBS left to right and see what happens.
Might not have an inner bearing or inner hub spacer seated properly.