light gap cover design

[warriorspeed350]

 

[warriorspeed350]

grey is aluminium
blue is blue
and black is black

 

[yamarider]

definitely 3

 

[dswwarrior350]

The one thats already on there is original. But if i had to pick id say 3

 

[klutchbuster350]

3 or 4

 

[imtarnished]

I Voted for 4, but what if you were to have something like #1 but the blue is black. I think i may have voted for that if you had that up there.
Though if you had where it was 2 black lines going horizontal (sideways) on the top and bottom with the aluminum in the middle like #1 but with black and sideways so it will follow the lines of the factory hoow a little more, instead of vertical lines on the cover, and horizontal on the hood, it's all horizontal.
~Bill
Just throwing out some other ideas...

 

[warrioracer08]

definetly 4 it goes with your whole quad better and would match the hubs

 

[corko1492]

hes right

 

[warrioracer08]

finally someone agrees with me

 

[xkingraptor350x]

umm yeah cant do any better on those then that?? comon now if i were to have one on there id keep the on thats on there now....JMO

 

[1blurappy23]

i definately go with 4 imo the colors look the best

 

[bad04warrior]

Yeah...4 is a good choice ;D

 

[warriorspeed350]

heres what i did.......

after (not lines)
before (lines)

 

[warriorspeed350]

i curved the lines a little bit

 

[corko1492]

whyd you put them stickers on there?

 

[warriorspeed350]

because i had to start the sticker placement somewhere...there is a MSRMX sticker on the hood now and a small thor head just under the gas cap

 

[warriorspeed350]

any other comments?

 

[warrior350]

Is that electrical tape?

 

[warriorspeed350]

yeah...it always has been