my first rebuild, could use guidence

[88' warrior 350]

Hey guys im in the process of doing my first rebuild and just had a couple questions . First off im putting in a wiseco 10.25/1 piston , cylinder is getting honed and its stock valves and springs with im thinking a stage 2 hotcam . I was wondering what size jets should i get and if anyone knows what the piston ring gaps should be , i would appriciate everyones input

 

[hammy7734]

i dont think you can put a stage two cam in with stock springs but i am not positive but i know you can do i stage 1 cam with stock springs and for ring gaps the wiseco piston will have that when you get it at least mine did and make sure you read the directions to convert the gap sizes cause i remember in the directions i had to do it i just forget from what to what. and for jets i have a dg rcm 2 exhaust and stage one cam but i am running 150 main and 45 pilot and 2.5 turns out on the fuel mixture screw

 

[88' warrior 350]

Hmm ill double check that might have to get a stage one .
And hows it run with those jets ?
also would running a cam change my valve clearance too ?
Thanks for the response too btw

 

[88' warrior 350]

Just checked and you can use the stage 2 cam with stock springs

 

[hammy7734]

ok i know with a stage one it doesnt change valve clearance but idk for a stage two but i am running mine at .07 for in take and .09 for exhaust

 

[lbjamm]

Stage two is for stroked and bored motors. Stage one would be better for your build.