New to me warrior starting issues

[Parks336]

Alright so I have looked around and looked around can't seem to find exactly what I'm experiencing.I recently bought an 04 warrior that had a starting issue.here's what I know for sure
1.it will turn over but not run by hitting start button
2.will crank and run by hooking jumper cables to a ground and positive to starter.
3.will start and run by pushing or pulling the four wheeler off

I got the four wheeler for a great deal,So therefor I'd like the troubleshooting to be minimum .thanks in advance..

 

[Franken warrior]

Sounds like a weak battery to me. Have you tried a different battery. I've read somewhere before that a weak battery won't allow the electric start to get it going because the engine isn't cranking quite fast enough. Especially if low compression or stretched cam chain.

 

[Parks336]

Going to try a different battery today,I'll post my results

 

[Parks336]

Went out and bought a new battery today,I hooked it up and the four wheeler just turns over but won't run,it stopped turning over and I jiggled some wires here and there then it would turn over again.it will turn over for a while but won't start..it tried to start once or twice but never did.....I pulled it off with my 400 and rode a while,then tried to start it the start button again,after messing with it (choke then no choke throttle and no throttle)it cranked up..I turned it off,ate supper went back out to crank it with the battery and it wouldn't it just turned over....so it cranked when warm but cold start it never would,plus I believe there is a wiring problem somewhere

 

[lbjamm]

Check all connections. Especially the grounds.

 

[frit91]

Check all connections. Especially the grounds.

Definitely check the grounds. I nearly had an infamous "Fritter Freak Out" because I didn't check all the grounds thoroughly. I got it straightened out but still can't find all of the "flying" tools.

 

[Parks336]

I'll go over everything today,I'll be installing new tie rod ends as well..hopefully I can solve this starting issue

 

[Parks336]

Ok so today was no help,the four wheeler has now stopped turning over by start button and even when I cross the syllenoid it just spins and never runs.pull the spark plug and it was dry.

 

[duneracerweston]

Did you check the main fuse and if the little black wire off the battery was still plugged into the harness.

 

[Parks336]

Yes fuse was in good shape,little wire run to the ground.?and I'm getting power to my rev and nue lights...

 

[Parks336]

Oh yeah gas will run out the bottom of the bowl and out the overflow with the screw out of the bowl but when crossing the syllenoid and hitting the gas the plug was still dry

 

[Franken warrior]

Do you know how to check your timing and valve lash? When I got my warrior, It would crank over but not fire. I found out my cam chain was stretched AND my exhaust valve adjuster screw was laying at the bottom of my spring. I had 2 problems. If the valves don't open or open at the correct time, you won't get it to pull fuel in or be able to push exhaust out. It might have compression but the stroke would be out of time. If it is stretched, replace it. Don't try to adjust a tooth because you'll bend a valve. It's actually pretty easy to check.

 

[Parks336]

I see that valves tend to be an issue with the warriors.what's the easiest way to check.?