Rear brake and sprocket on Warrior

[MidwayUSA]

Anyone know if an 05 or newer Raptor rear brake rotor will bolt up to a Warrior hub?
Also is there a 38 tooth sprocket that will fit the Warrior hub?

Reason I am asking is I have 20" tires on the Warrior and the Raptor. The Warrior gets hung up all the time but the Raptor doesn't. I noticed the rotor on the Raptor is quite a bit smaller and with the 38 tooth sprocket, I was able to tuck the skid up a little further.

I want to convert the Warrior over to the Raptor stuff to gain ground clearance. I was looking at the carriers and the caliper tabs are shorter on the Raptor and I think I can just re-drill the Warrior tabs so the caliper lines up.

Anyone ever done this? I know it would be easier to just buy a complete Raptor carrier and axle, but they are not cheap even used.

 

[elwood]

should be able to pick up a spocket anywhere. As for the calipar I'd get on bikebadit or something and pull up the parts finche for each quad and see if they have the same part number it might be an upgraded part

 

[duneracerweston]

Should work I have skids that give you more ground clearance then just a regular skid will

 

[MidwayUSA]

should be able to pick up a spocket anywhere. As for the calipar I'd get on bikebadit or something and pull up the parts finche for each quad and see if they have the same part number it might be an upgraded part

I measured this evening and the bolt circle is different. I still think I could re-drill the warrior bolt circle in the rotor and make it fit. I just want to stay with the 20" tires and end up with the ground clearance that the Raptor has. I think you are right on the sprocket, just depends on how much money I want to spend.