Rear Drive Axle

[warriorrider13]

So far so good. But when I was taking the bearings out the rubber seal popped out before it. Can the rubber seal go back in? Plus that pipe in the middle when it was in, it was very wobbly. Could this be a problem? Or is it supposed to be like that? My dad says I need new rubber seals as well as new bearings.


Lol the bearings were ****! They could barely spin.

 

[yamarider]

I got the pivot works bearings, which came with the rubber seals. I would replace the rubber seals because if they are worn out they will let dirt and water in, and you'll be replacing your new bearings before you know it. I think the spacer tube you're talking about was a little loose on my warrior too, but I can't remember for sure. I wouldn't worry about it.