rear master cylinder

[bowtiecb]

whats the trick to get the freezed up plunger out? im trying to rebuild it, but the spring and plunger wont come out

 

[duneracerweston]

heat heat and heat from a hand held torch not a cutting torch but a propain torch will work the plunger will met long before the mastercylender will so dont worrie about it melting to it aftr you think its hot enough hit the bottom of it on a anvil or something also want to make sure its completely off the bike and has no rake fluid left in it

 

[bowtiecb]

thanx, i got it soakn with lithium, ill clean it with carb cleaner and torch dat sucka

 

[duneracerweston]

Don't get it to hot and melt the master cylender

 

[bowtiecb]

got it out and put back together,but the rubber at the bottom of the plunger keeps gettn twisted.do anybody run theres without the last rubber,i didnt c it n the old one anyway.

 

[duneracerweston]

I run it with the rubber it keeps it from getting full of dirt and all the crap

 

[bowtiecb]

I run it with the rubber it keeps it from getting full of dirt and all the crap

im not talkn about the boot, http://www.yamahapartshouse.com/yam...EHICLE)/REAR_MASTER_CYLINDER_(YFM350XD_-_1992). look @ the section #2 and its the rubber piece right below the aluminum plunger.

 

[bowtiecb]

nevermind im just go buy a new 1

 

[duneracerweston]

im not following sorry i dont understand what rubber part your talking about

 

[elwood]

looks to me like #2 in that finch includes the rubber boot

 

[bowtiecb]

in this picture you have the boot, the lock ring, and the stud, and the rubber right above it is the piece im talkn about.