Reverse *******

[warriorrider13]

I wanna take my reverse shifter off but there are those 2 wires that go onto it, what do I do about those? And should I cover up that hole from the bolt that goes to the engine?

 

[schppppeeiiddiiiee]

y?

 

[warriorrider13]

Because I dont like the reverse and it doesnt work.

 

[schppppeeiiddiiiee]

i've never seen one not work....

.. just leave it...

 

[boxhead]

It needs to be adjusted probably, the rod isn't set to the right distance.

 

[warriorrider13]

OK, well is there anyway I can check to see the right distance?

 

[schppppeeiiddiiiee]

it either works or doesn't lol

 

[warriorrider13]

after I pull up on the shifter and once I move it backwards it stalls

 

[schppppeeiiddiiiee]

did you pull the clutch?

and you don't need to put up on the shifter... you just have to pull the clutch.. lift the lever, and move it back until it clicks into position.

 

[boxhead]

I think he means the reverse lever... You'll probably need to shorten the length of the rod, since you pull the lever back the part that goes in the motor isn't pulling up far enough. Check your clutch free play, and also warm your motor up good before doing a test. I've had the reverse act funky while the motor was cold once before. I'm assuming things will start going a lot better once you adjust that rods length though.

 

[schppppeeiiddiiiee]

i've had problems of.. when it's cold the reverse won't disengage..

 

[warriorrider13]

OK thanks