Safety switches what to do with them?

[YAMAHAULER]

By the way the 2 safety switches that were on my original clutch perch with the parking brake what should I do with them?

 

[bones]

for the clutch one you just cut it off and wire the 2 wires together and the brake one im not sure as the 87 only has the one

 

[akaguppy]

i cut the two wires and capped each one and sealed them off as far as the brake clutch i did as above

 

[YAMAHAULER]

It starts and runs just as they are I just tucked them down by the steering stem I was just wondering if they will interfere with anything if I don't do anything with them

 

[1998yamahawarrior]

The clutch switch should have bullet connectors under the hood that are opposite ends when disconnected. Unplug the switch from them and plug them together.

Never had to do the brake switch so Im not 100% sure how to do that one. All of mine have already had it bypassed when I got them.

 

[YAMAHAULER]

plug what together? like the connectors for the headlights

 

[1998yamahawarrior]

I call them bullet connectors(probably actually called something else). Follow the clutch switch down and you will run into them. Wish I had a pic of them so you knew what I was talking about.

 

[YAMAHAULER]

here is the clutch plug I unplugged and connected the male and female ends together under the headlights

and here is the end of the parking brake switch it wasn't plugged into anything just haning loose under the headlights

 

[1998yamahawarrior]

Yep you got the clutch switch bypassed correctly! Youll have to wait for someone else to chime in for the brake switch

 

[YAMAHAULER]

well the brake switch wasn't plugged in at all but I figured I would eliminate the parking brake cable since the parking brake didn't ever work and without the switch the brake light still works so I don't think it'll be an issue