Thanks to dave & other that contributed!

[fredybender]

Finally got the bike to run properly;
Dave's input on the clutch stuff was extremely helpfull. Thanks again! (That clutch gave me a friggin hard time!!!)
So; Barnett clutch, up & running with extra steel plate, new tie-rods& tie rod ends all over, new wheel bearings in front, New brake pads all over, new "X" ring chain, new sprockets (2) 14-40, new Kenda dominator's 20X11X9 rears, K&N cleaned & re-lubed, New plug, new oil... Duhhh..
Ordered, but will go for a ride or two first; 0.040" oversize Wiseco piston, top end gasket kit

Time to RIDE !!!

Thanks for all the guys that gave me input...

Fred