Warrior electrical problem. HELP

[Warriorfreak99]

I have a 2001 warrior 350 and a 99 parts bike and the cases broke on the 2001 motor so i swapped out the bottom end using the 99 cases and trans and the 2001 top end, which i rebuilt during this process. I wired everything up and now the starter wont turn when i hit the button, but it will turn when i cross it up at the solenoid using a screwdriver. I've swapped the wiring harness out the with another, still nothing. i changed out the ignition coil, still nothing. changed out the handlebar switch with all the controls on it and im still dead in the water, any ideas??????

 

[alex456123]

The solonoid is dead replace it.

 

[Warriorfreak99]

Thanks man i'll try that

 

[Warriorfreak99]

Not the solenoid, maybe the stator?

 

[YAMAHAULER]

bad connection and or dirty terminals maybe even bad starter
stator would have nothing to do with it not turning over

 

[WV98YFM350]

ALWAYS check your fuse!? If ya haven't try jumping across the solenoid with a screwdriver. If it rolls over that way, probably a fuse. Just my 2 cents (probably worth about that too lol)

 

[Warriorfreak99]

i put a new stator in it and it started right up when i crossed it up at the solenoid but the button still isnt working at the handlebars

 

[WV98YFM350]

did u buy new or used for the handlebar switch?

 

[99 350]

ALWAYS check your fuse!? If ya haven't try jumping across the solenoid with a screwdriver. If it rolls over that way, probably a fuse. Just my 2 cents (probably worth about that too lol)

X2, I couldn't figure out why mine wouldn't until I found where the fuse was and it was broken in half

 

[Warriorfreak99]

it was the switch off of my parts bike. probably bad also

 

[Warriorfreak99]

Stator was why it wouldn't start but i still have no power at the handlebars, my reverse and neutral lights arent working either

 

[WV98YFM350]

It sounds like your key switch. replace with new, then update us.

 

[WV98YFM350]

you can find a new switch on amazon for less than 10...

 

[Warriorfreak99]

if it was key switch it wouldnt start when i crossed it up at the solenoid

 

[WV98YFM350]

It would if it (key switch pigtail) was hot wired to start without turning the key...you should have neutral light as soon as you turn the key, thats why I say that is what I would change out first.