2000 warrior running problem

[warrior1121]

my warrior wont idle. it only idles when i turn the idle screw up. but the rpm is too high it seems like if it is at idle it wont start but when i turn it up its fine. it also seems like when i hitt lots of water it dies out to. i was wondering what this is please help maybe stator. i already changed the cdi whats next

 

[yamarider]

It's gotta be a carb issue, nothing electrical would work only at certain rpms and be affected by the idle setting like that.

Did you check for air leaks? The intake manifold rubber is known to crack around the middle on the 350's.

Has the fuel screw been adjusted at all? It should be 2 or 2 1/2 turns out from fully clockwise. If it's turned in too far it'll cut off fuel and won't idle.

If everything looks good, the next step would be to take the carb apart and give it a good cleaning. It sounds to me like the pilot jet is clogged. The reason it would run with the idle screw cranked up high is because after a certain point in the throttle, the needle jet starts to take over fuel metering.

 

[warrior1121]

ty u are the only 1 who answered me in 2 months