3 mashed fingers and its still stuck on there how the HECK do i get this off ???

[duneracerweston]

Ok so I've got a gytr exhaust silencer and HOW THE HECK DO I GET THE END CAP OFF?????? I can't get it off to repack it and I've already mashed 3 fingers trying and I'm lost and yes its unbolted

 

[mopar1]

You're one of the few and maybe the only active member on here that's running a GYTR can out the back. I don't know what to suggest.

 

[ryder133]

Plasma Cutter?

 

[elwood]

not sure about the GYTR but look at the whole thing, not just the end cap, my fmf came apart after taking out the allan screws that were toward the front of the muffler. And everything had high temp silicone on it, including my endcap

 

[duneracerweston]

Ugh high temp silicone not a good sighn ok so ill try taking it apart from the front too didn't think about that

 

[elwood]

high temp silicone was factory, and I used it again when I put it back together, helps seal it tight and stop rattles

 

[duneracerweston]

Ya but its a pain to get back off!! It dose work perfect to seal the head pipe though