carb kit

[3ffreak]

Hey there. ok I added a DG slip on pipe, K&N air filter and a Dynojet kit for the carb. My problem is I can't find the air idle mix screw. It says in the kit to turn itin then back it out 2 turns. Where they show it in the pic it looks like it's solid brass??? Thanks in advance for any help and enjoy the ride

 

[lt1chevy210]

You need to drill out that plug. The mixture screw is directly below that brass plug. I bored the plug out with a 1/4" bit (if I remember correctly) until I able to pry the plug out with a screw driver. Hope that helps.

 

[Binky]

try and find the factory specs, it might already be at 2 turns and you wouldn't have to drill

 

[3ffreak]

Thanks for the help. I had to give it half a turn.......much better