Carb question

[mudbogginsouthernboy]

If I buy this carb will I have to buy jets with it? http://item.mobileweb.ebay.com/viewitem?itemId=190810394615&index=6&nav=SEARCH&nid=97890083259

 

[Gen1Pat]

If it comes with stock jetting (which it probably does) then no. If you have any mods that require a re-jet, yes. But, you can buy a 38mm Mikuni round slide that will perform a bit better for the same price, or less.

 

[mudbogginsouthernboy]

I got a bigger piston and after market exuast. Can you get a link for the one your talking about? Thanks

 

[lbjamm]

Is your carb shot?

 

[mudbogginsouthernboy]

Pretty much

 

[lbjamm]

IDK. Pretty spensive. Think I'd buy a used one and rebuild it. Heck I'd rebuild the one you have. How bad is it? Not trying to be an ass, just saying.

 

[lbjamm]

I just looked on E-bay. Man the used carbs are spensive too.

 

[Lbswut]

I hate you for typing spensive multiple times.

 

[alex456123]

I hate you for typing spensive multiple times.

... Really? Things are spensive man!

 

[lbjamm]

I hate you for typing spensive multiple times.

Y. you one them spellin structors? LOL

 

[Lbswut]

Perhaps.

 

[Rockgrenade]

DERAIL! Bak On ToPiC.
Rebuild your carb. I checked as well. Either rebuild or get out your checkbook.

 

[mudbogginsouthernboy]

Well mine poors gas out

 

[alex456123]

the float is stuck then... why didnt you say that in the beginning?

 

[mudbogginsouthernboy]

no it poors gas out of the bottom of the carb. it wont start
http://www.youtube.com/watch?v=1eFVvEwNaf0

 

[alex456123]

is the gas coming out the tube on the bottom?

 

[mudbogginsouthernboy]

no out of the bowl i know if it was coming out of the tube it would just be the float sticking

 

[lbjamm]

Did you try putting in a new needle valve?

 

[mudbogginsouthernboy]

no because i dont know anything about carbs. i was hoping you guys on here would know.

 

[lbjamm]

That's the first thing I would do if you haven't already set the float height. Just take off the carb. Remove the float bowl. Slide the float hinge pin out. Change the float needle seat. Make sure the o-ring is not damaged. Put the new float needle in and reinstall the float. Adjust float height and your good to go. There should be a manual in the stickies that should help also. If you have any ?'s just ask.