Clutch dragging need help!!!

[jvhorn1]

Just put in a new clutch (fiber and steel. new springs) from Barnett. Clutch will not disengage. This was the reason (along w/ slippage) for changing. I have adjusted the cable at both ends with no effect. Did not put in the extra steel, just the new stuff.

Part of my question is in regards to the small clutch boss springs. I put them where it is shown, but when reading the instructions from my Cly-mer book it says that they are supposed to fit inside of the small fiber disks. What is right?

Also on the top of the case there is the two marks that the arm is supposed to be in between, how far should the arm rotate before the slack is gone from hitting the pressure plate?

Any ideas or suggestions??

Jason

 

[jvhorn1]

Anybody?

 

[jvhorn1]

OK? So nobody has had an issue like this before?

 

[lowbaby]

the two marks on the case dont work. I read the same thing but if you look at some pics of other peoples bikes they are all about an inch forward from the two marks.

 

[jvhorn1]

Thanks

 

[jvhorn1]

Nevermind, I got it.

Jason