DRW: Building a 4Valve 374cc Warrior Motor

[txdunerider]

Sweet, did you have work done to the Trans too?

 

[Gen1Pat]

Guess I'll have to ride my warrior out there to meet you guys. Cheaper on gas. lol. How I want so badly to carve sand again...

 

[duneracerweston]

Hah! We will haveto set up a trip!

Tx yea im having cv4 go through the trans and hard parts to de burr and smooth, and harden them to reduce friction and engine temps.

 

[txdunerider]

Micro polishing does wonders for Trans temps and smoothness

 

[duneracerweston]

That's what I was wanting, cooler temps, it was averaging245* off the head and 225 on the bottom of the cases.

 

[txdunerider]

Sweet , when I put the new crank in my raptor I am having it bushed and micro polished as well. I am sure it would do wonders on the warrior may be something I look into if I build the warrior up

 

[duneracerweston]

well we shall see, as far as i can find im the first to try it on these 350s hope it will do good.

 

[357warrior]

does all the bolts line up even where the timing chain is. just wondering i mmight do this mod with the 388 kit

 

[duneracerweston]

close but not perfect, im not sure it will work just yet, or even how much it will cost!

 

[DeadLastRacing]

update?

 

[duneracerweston]

Its not looking good for it. Still gonna look at a few more things before I give up on the xt head.

 

[airb]

What troubles are you having, are you having trouble with the timing gears? I was seriously considering doing this build after I saw this thread.

 

[Gen1Pat]

He's having trouble bolting the head down.

 

[duneracerweston]

Its a complex pain in the ass. I have other builds in front of this one. I have a kfx450r motor to build. And a tecate250 blaster hybrid both to finish before thanksgiving.

 

[offroadrider12]

Updates?

 

[Beastmode17]

Weston hasn't been on here In a month or so, That's the reason they haven't been any updates.

 

[2000]

Its not looking good for it. Still gonna look at a few more things before I give up on the xt head.

Have you done anything with this build since last time you updated? Could you use a xt350 cylinder?

 

[duneracerweston]

I have not messed with this. Getting the Cnc table going with a full time job and fiancé takes all your time lol

 

[2000]

I have not messed with this. Getting the Cnc table going with a full time job and fiancé takes all your time lol

The suspense is killing me. I cant wait to see it. What does it need machined?

 

[duneracerweston]

A lot lol