duneracerweston
Well-Known Member
Seeing as the parts side of DRW will be taking flight once again soon, but the intakes will not be on that list of production parts, i figured id give you guys the how to on it. (yes i know its the wrong section for a how to but it will get more traffic here.)
The tube actually consists of 4 sepereate pieces not counting the clamps or filter itself.
the parts are the upper tube, lower tube, the middle band and the filter flange.
parts list.
1.5 inches of 3inch outside diameter tube.
1.5 inches of 4inch outside diameter tube.
3x 2-4" hose clamps
1 4-5" hose clamp.
4" K&N HA-4250
the tubes will take some trimming to get to the propper length.
these intakes are the best out there for these when built propperly and with common sense. ill upload pictures later.
(the mount for the filter to keep it from flopping around will also need to be built but thats one for personal preference.)
-DRW
The tube actually consists of 4 sepereate pieces not counting the clamps or filter itself.
the parts are the upper tube, lower tube, the middle band and the filter flange.
parts list.
1.5 inches of 3inch outside diameter tube.
1.5 inches of 4inch outside diameter tube.
3x 2-4" hose clamps
1 4-5" hose clamp.
4" K&N HA-4250
the tubes will take some trimming to get to the propper length.
these intakes are the best out there for these when built propperly and with common sense. ill upload pictures later.
(the mount for the filter to keep it from flopping around will also need to be built but thats one for personal preference.)
-DRW
Last edited:
