Lower roller

[Dballard87]

I feel like my chain rides on this thing to much and it makes the most annoying noise when I'm goin down the road is it supposed to?

 

[jeffsyfm350x]

Yea they do. A lot of us did away with them and use rollers with bearing but u will have to make a few mods to make it work but well worth it.

Sent from my BlackBerry 9310 using Tapatalk

 

[Dballard87]

so what all can i do could i just lower the post and then put a roller with bearings on it? or just put on the roller with bearings?

 

[lunaracing]

Yea they do. A lot of us did away with them and use rollers with bearing but u will have to make a few mods to make it work but well worth it.

Sent from my BlackBerry 9310 using Tapatalk

:tup:

 

[lunaracing]

I had a spare from my yzf450 and just made a new stud for it,bit more work but way worth it and they last a lot longer..

 

[Dballard87]

I think I can move the post it's self down an inch or two plus I'm going to tighten the rear shock and adjust the chain tonight so hopefully it will help

 

[Beastmode17]

I fabbed up TM Designworks rollers for my 350 and they are quite and have lasted close to 3 years.

 

[Dballard87]

Just hate the freaking noise it's annoying

 

[jeffsyfm350x]

Just hate the freaking noise it's annoying

I wouldn't move the post there's really know where's to put it and if its not right you might end up throwing a chain and get wadded up in your case then your f ed.


Sent from my BlackBerry 9310 using Tapatalk

 

[Warriorfreak99]

getting a case saver from weston wouldnt be a bad idea...if hes making them again not sure.

 

[jeffsyfm350x]

getting a case saver from weston wouldnt be a bad idea...if hes making them again not sure.

Even then its only going to take so much abuse and it will give eventually. I've had case savers ripped right off on other bikes. Best thing to do is what me, lunaracing and tim said.


Sent from my BlackBerry 9310 using Tapatalk

 

[mrjim0214]

havent you guys been using skate board wheels?

 

[Beastmode17]

I think Bones runs the poly skateboard wheels on his, My buddy ran some on his LTR and they worked damn good if not better than most.

 

[Dballard87]

Idk what ima end up doing for nowi moved the top roller to the Botom and I cut a chunk of polyeurathane pipe and am using it for the top works good just a little racket