Installed a new clutch last night, also added 1 extra thin disc. I replaced the clutch cabel with a new motion pro terminator cable. After adjusting to where I have a real good clutch, the adjusting screws seem awful far out along this the lower adjustment. Is it ok to pop the c-clip on the lower clutch arm and move it a couple notches?? Maybe the motion pro cable is a little longer than it should be?
ps. I used a EBC clutch.. and it's finally nice to actually have a full clutch with no grabbing.
ps. I used a EBC clutch.. and it's finally nice to actually have a full clutch with no grabbing.
