pb delete

jgray44 · Feb 22, 2011

Going to put on a new clutch lever and delete the brake, instead of cutting wires and splicing them can I just zip tie that plunger donw that u pull out of the lever? Or do I have to splice wires?

bones · Feb 22, 2011

you can just unplug them lose the switch and plug the wire in to each other its vary easy

ksowin87 · Feb 22, 2011

bones said:
you can just unplug them lose the switch and plug the wire in to each other its vary easy

AGREED! I did the same thing...very easy and no splicing required! Plus it would look better...less unneeded crap hanging around.

elwood · Feb 22, 2011

ksowin87 said:
AGREED! I did the same thing...very easy and no splicing required! Plus it would look better...less unneeded crap hanging around.

yep that's how your supposed to do it.

jgray44 · Feb 23, 2011

so the wires that come out of the plunger switch thats connected to the lever leads to a junction box? or what? guess im just a little confused. it would be easier if i was near my quad but its at a buddies house and im having trouble picturing what i need to do

elwood · Feb 23, 2011

Take your hood off, follow the wires from your handlebars, there will be male/female plugs. On the engine side plug the 2 wires together. then just cut the wires off on the handlebar side. You can then remove the entire parking brake cable and I'd replace the parking brake part on the rear caliper with a block off plate.