porting

[buzzy613]

i i sent my head out to get proted would i notice a difference in power?

 

[duneracerweston]

What else have you done to the moter? Piston higher comp? Cam? Oversized valves?

 

[DeadLastRacing]

It'll help and better accentuate any other engine mods.

 

[buzzy613]

nothin bone stock in the motori was thinkin of doing bigger valves. but i dont know what i all want to do yet

 

[duneracerweston]

Poring will help but not a ton because your running a all stock motor it dose best on modded motors

 

[buzzy613]

i might get the head milled .010 and get it ported, recut the valve seats and get my carb boared to a 37mm

 

[duneracerweston]

then porting it and if you camed it that would be worth doing

 

[buzzy613]

hot cams or web cams?

 

[duneracerweston]

If you are already planning to change valves then web if not the hot cam

 

[buzzy613]

ill run stage 1 hot cams

 

[starpuss]

i did my head. and the intake. too bad i never drove a warrior in like 8 years so ill not know if it's faster.

 

[buzzy613]

ima just do a little bit of work to the motor ill get the valves re-cut and just get the head milled and replace the cam chain

 

[buzzy613]

any thing else i should do to it like re-ring it or any other little stuff?

 

[elwood]

any thing else i should do to it like re-ring it or any other little stuff?

I would you are there anyway, maybe a higher compression piston

 

[beastlywarrior228]

you have to watch porting though the trick is to clean it up not open it up. opening it up may interfere with the important intake velocity