3504life
Well-Known Member
on my rear axle my brake rotor and sprocket have come play. i was wondering if its the 2 lock nuts on the side i have to adjust of is it the bearings are starting to go has any one else had this problem?
rear axle loose?
- Thread starter 3504life
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
hawkster0001
Well-Known Member
- Joined
- Apr 15, 2010
- Messages
- 681
- Reaction score
- 0
possible those came loose, if theres play in the two hubs, but it doesnt like rock back and forth on the axle then you just nee to tighten it. you can buy the 40$ tool from yamaha, or use other ways such as pipe wrenches (my personal way) or a hammer and a big chisel, assuming you dont have wreches to fit those nuts, nobody does
bassballs818
Well-Known Member
Before so just check to see if the whole axle rocks. Mine did and when i changed them it didnt move and that was before i even put the nut on. Better to do it sooner than later.
I dicovered an awsome way to tighten the nuts, it could work to take them off also. I put a C clamp on one and a wrench on the other. Apply the clamp to the inner nut. Take a strap and tie from the rear grab to the clamp. Break outter loose and its easy from there sorta. Worked for me when i put on. Think outside the box.
I dicovered an awsome way to tighten the nuts, it could work to take them off also. I put a C clamp on one and a wrench on the other. Apply the clamp to the inner nut. Take a strap and tie from the rear grab to the clamp. Break outter loose and its easy from there sorta. Worked for me when i put on. Think outside the box.
