rod play

[DAN]

is this bad?

 

[DAN]

it didn't attach first message

 

[DAN]

I do have a high compression piston also

 

[beastlywarrior228]

Just no up and down

 

[DAN]

Thank God I was so worried I knew some kind of play was bad I checked for up and down and there weren't none, thanks

 

[DAN]

Any tips on putting the flywheel back on? I'm having problems with that I thought I torqued it down but when I put the cover back on it spun both ways so I guess I didn't do it fully

 

[beastlywarrior228]

Any tips on putting the flywheel back on? I'm having problems with that I thought I torqued it down but when I put the cover back on it spun both ways so I guess I didn't do it fully

Make sure the woodruff key is staying in properly. Flywheel also gets torqued down with the cover.

 

[DAN]

with the cover? do you mean I have to torque it down with the cover on ?

 

[DAN]

my key was a bit loose do I just carefully hammer it in?

 

[beastlywarrior228]

What do you mean by loose?

 

[DAN]

it wiggled a lot

 

[beastlywarrior228]

The key shouldn't have a bunch of slop in the key way.

 

[DAN]

okay thanks, remember we were talking about the extended a arms? what do I do to balance out the back can I just add wheel spacers? I head they ruin the hub though and put extra pressure.

 

[beastlywarrior228]

okay thanks, remember we were talking about the extended a arms? what do I do to balance out the back can I just add wheel spacers? I head they ruin the hub though and put extra pressure.

You could do that, buy some
Yfz450r hubs or just get a niche axle.

 

[PineyPower]

You could go broke boy status and flip the rear wheels too, the rear is already wider by an inch each side and flipping the wheels makes it about square.
Fwiw I've got the niche axle, you might have to cut the groove a little deeper for the snap ring to sit but otherwise it's been pretty solid, I like that the axle nut is like a 32mm and you can torque the balls off it

 

[DAN]

Thanks
This one?

 

[PineyPower]

Yep. If you dig through my posts I have a good picture of what needs to be cut

 

[DAN]

ok thanks