steering stabilizer/dampner

[bickel76]

here ya go.

if these pics dont show enough, let me know and i can snap some more. the only other way that i can see mounting this is the other way around. pointing towards the back of the bike. the problem there is that is right where the brake lines cross and i didnt want the shock absorber that close to the motor. if you can think of a better way, let me know because i'm not too crazy about it sticking out the front. especially if i go over the bars.

 

[klutchbuster350]

Ha, It does look kinda like a unicorn, You really should relocte it, If you go over the bars that thing will **** you up, or if the quad falls front end first, the stabilizer will get ****** up.

 

[bickel76]

i wish i could relocate it. i pulled it off earlier today and i couldnt figure out any other way to mount it. i wish someone else had one on a warrior. i've been trying to check the other forums but i havent had any luck. maybe someone else will pick one up and maybe they will have better luck than me. the only thing i can think of is doing some fabrication work. i totally agree with you about going over the bars.

 

[bickel76]

here is the best i could do. flipped the bracket around and turned the entire thing upside down. i could get it flatter, but then it hits the bumper. hopefully an aftermarket bumper will fix that problem. let me know what you guys think. you can see from the side shot that it is just barely above the bumper and just behind it.