Won't Start?

[Golfaholic]

Good day all, I am new to this forum. I recently got a '99 Warrior 350. It will turn over but will not start. It has good spark coming from the plug, good compression and a brand new carburetor. From what I can tell it has the clutch and parking brake bypass already done as well. I am at a lose as to what could be stopping it from starting. Any and all assistance with this is greatly appreciated. Thank you all in advance and I hope you all have a great day.

 

[Banshee32379]

Check the timing

 

[87warrior917]

Are you sure fuel is filling the bowl?

 

[Golfaholic]

Check the timing

Are you sure fuel is filling the bowl?

Yes, I have even tried starter fluid in the plug and nothing.

 

[87warrior917]

Yes, I have even tried starter fluid in the plug and nothing.

You may need to Ohm test the stator. It may not be getting a good enough spark? Have you tried bump starting it?

 

[Golfaholic]

You may need to Ohm test the stator. It may not be getting a good enough spark? Have you tried bump starting it?

No I am planning on trying to do that this weekend when my buddy can help. I will also check the ohms for everything. Thank you

 

[Golfaholic]

Check the timing

Just made sure it was in time and still not firing up.

 

[Banshee32379]

What’s the compression read

 

[Golfaholic]

What’s the compression read

It reads between 120-130.

 

[Banshee32379]

You said it has a brand new carburetor is it a mukuni?

 

[Banshee32379]

You said it has a brand new carburetor is it a mukuni?

The cheap Chinese carbs have a jet problem you have to use your old jets out of the old carb otherwise you’ll have problems

 

[Golfaholic]

The cheap Chinese carbs have a jet problem you have to use your old jets out of the old carb otherwise you’ll have problems

What problem do they have? I can see them spraying fuel when I use the throttle.

 

[Adaboy101]

Pull the spark plug out, ground it to the cylinder and turn the engine over. See if it's sparking, even if it is sparking, if it's an old plug, replace it. It could still be bad, sometimes plugs will spark outside the block, but won't spark in the block under compression!

 

[Golfaholic]

Pull the spark plug out, ground it to the cylinder and turn the engine over. See if it's sparking, even if it is sparking, if it's an old plug, replace it. It could still be bad, sometimes plugs will spark outside the block, but won't spark in the block under compression!

I have checked the spark; however, I am planning on getting a new plug tonight and seeing what happens.

 

[Adaboy101]

I have checked the spark; however, I am planning on getting a new plug tonight and seeing what happens.

Worth a shot! I always replace the plug if I can't get something running, if it does fix it, great! If it doesn't, it was 5 bucks at the most, and when you get it running you'll have a new plug.

 

[tomcat]

Try spraying starter fluid in it, while you're turning the engine over. Could be a number of things like cdi box, pulse coil, stator, bad ignition coil, bad spark plug cap. There should be a strong orange white spark, if everything is working right. you need a multimeter and a service manual.

 

[Golfaholic]

Try spraying starter fluid in it, while you're turning the engine over. Could be a number of things like cdi box, pulse coil, stator, bad ignition coil, bad spark plug cap. There should be a strong orange white spark, if everything is working right. you need a multimeter and a service manual.

I have tried the starting fluid, but I have a new ignition coil, stator and cdi module, planning on replacing them this weekend. So hopefully these will be the fix.

 

[tomcat]

Well, with all them new parts, I'll think you'll probably get it running. Good Luck!

 

[kc rawlins]

So I have an 04 raptor 350. I have replaced everything from the stator all the way to a new wire harness. This thing spins over great, has fuel fire and compression. It will not roll start at all. Put it in gear let off clutch it'll lock tires down and slide. Any info or help is appreciated thanks

 

[Banshee32379]

Have you done anything with the transmission inside the case