YES!!!! finally go the sprocket hub off!

[hawkster0001]

came off finally, but it sure as hell didnt want to, heres a pic of it after wards: Its still reusable right? ;D

 

[kyler]

sure it is... just put some duct tape and some twine and maybe a clothes hanger and u r good to go! lmao jk jk

 

[beastlywarrior228]

HOLY CRAP

 

[hawkster0001]

i guess you gues didnt quite get what i meant by "its stuck" theres not much left of the "it" now, and kyler: i dont have any ductape left, but i think some masking should do the job.

i bought a hub and sprocket off ebay for 20$ with shipping

 

[tyler]

Ahh hell thats nothin just bend the TWO REMAINING tabs that hold the sprocket on straight and slap it back together!!!! LOL LOL LOL

 

[hawkster0001]

i dont htink theyd go back if i tried, i heated the hub up till it was glowing red and whacked it 20 times with a five pound sledge, and it didnt move, then i had to cut it

 

[miami1]

it looks like you might have ground on the splines a little. lol

 

[hawkster0001]

just a tiny bit, nothing a file wont fix, the big gap is from me bending the hub open

 

[tyler]

^ haha ok i was going to say if thats from a grinder, the splines on the axle are prolly jacked!! lol

 

[hawkster0001]

yeah i ground it down til i came in contact withe the splines so theres was a 1mm gap, then did the other side and pried it open