Any ideas of how to blast a swinger with out removing the bearings or should I remove them and same with the stock carrier what's the easiest way to do it
tape them off and be careful that is how Todd did the swinger on #5
leave the pivot bolt in so you have something to wrap the tape to and I left the end caps on too
Cool bro I gotta brake down the frame on the black widow tommorrow and paint it all after prep of course but I have a 6 foot blasting cabinet so I figured I'd get som ideas before I destroy bearings
Thanks bro I don't wanna over kill it on first rebuild but I figured it would make a nice upgrade after p&p it should reach and hold a steady amount of thrust off the line and good mid and top end power
From start to finish the rain didn't stop me from getting the rear end painted don't have much time with working everyday but I'm getting it done step by step looking more like a black widow
Besides I everyone's been helping me with stuff nothing so expensive but it all helps an he needs an axle so I'm buying the one I want and he can take mine
My buddy's with there 400exs all dash on me cause I ride a warrior they've laid off since I started modding it but I couldn't resist I sent them this pic with the following caption
Oh your running stock that's cute! This should go nicely with my motor build