starter clutch help

[zaffiriw]

Help I am trying to replace my starter clutch. I have a 89 warrior, But I cant seem to get the flywheel off. There are six 5mm allen screws holding it on and I cannot get them to budge. Or is it possible that they are not what is holding it on? Can anyone help with some advice on how that thing comes off.
Thanks for any help.

 

[jbullfrog63]

No you dont have to take the allen screws off. The center bolt is the only thing that holds it on. You have to buy a flywheel puller to get it off there, cause its pressed on. The allen screws hold the starter clutch to the flywheel, it will come off as an assembly.

 

[mopar1]

When you are pulling the flywheel off, be sure to hold the stator rotor and flywheel/ring gear together or the little "dogs" (or bearings) that ride in the starter clutch will go everywhere and one always goes into the bottom of the case.

 

[bomber315]

yeah you need one of these:

http://cgi.ebay.com/ebaymotors/FLYW...9884170QQptZMotorcyclesQ5fPartsQ5fAccessories

youll still need to take those PIA allen bolts out but whats after you get the flywheel off

 

[Buckethead]

Quick question...is there a special alignment for the flywheel and starter clutch? I got the 6 allen bolts out then realized that it spins freely.