jetting on raptor 350

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

yamaha350rider

New Member
Joined
Jan 29, 2007
Messages
2
Reaction score
0
i just installed a hmf slip on pipe is there a chance of me blowin up my engine if i dont adjust the jetting?
 
If all you did so far was put on the pipe just take the 30 minutes to pull off the gas tank get to the top of the carb and drop the needle clip to the bottom position. There are 3 clip positions on the stock needle on the 350, stock it is in the middle. This is what HMF calls for on their jetting specs for the 350 with only a pipe.
 
Back
Top