I just got a stage 1 Hot Cam for my 98' Warrior. The instructions say to take the inner valve springs out during break-in. Is this a must do? I mean if I'm using a good assembly lube, will it not be ok? Also the instructions claim that if the Cam chain is over a year old, replace it when installing the new cam. Does everyone do this? And for those that didn't, did it create any problems?
Hot Cams break-in Instructions
- Thread starter killface
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
bones
Well-Known Member
i didnt and never had a problem
87warrior917
Well-Known Member
My old motor with a Hotcam I never did any of that lol except for the cam chain. It needed replaced. My new motor with a web cam I just installed it with assembly lube, ran a few heat cycles thru it, changed oil a few times and called it good.
