DaWarriorGuy29
Member
I'm thinking about putting a high compression piston and camshaft in my Warrior. I want it to run on pump gas, and I don't race at all, just trails. What setups would you guys recommend?
Piston and cam
- Thread starter DaWarriorGuy29
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
The first step I usually recommend is a wiseco 11:1 and stage 1 hotcam. If you want to also do springs in the head then web .390.
PineyPower
Well-Known Member
Them hotcams still have problems with the gear or did they sort that out?
DaWarriorGuy29
Member
I was thinking about the Stage 2 Hotcam. Is it a good cam? Also would I loose any power in the bottom end or would the 11:1 compression compensate for that?
11:1 would add low end. I still get the stage 1. I think that works perfect with a stock head.
DaWarriorGuy29
Member
What about Webcams? Do you like them, specifically the .430 cam because I want a top end cam?
Yes that's a great cam. I would only recommend if you are also porting the head to take advantage of the extra lift. You will also need upgraded springs.
If you want a top end cam with ported head the megacycle .450 is the way to go.
DaWarriorGuy29
Member
Where can I get it ported at or can I do it myself?
Send it to drw @duneracerweston on here
The_Mistress $$$
Active Member
Recommend sending it too weston also he will set the head up for what your looking too get outta the bike
