warrior stu
Well-Known Member
was looking at it last night and if i use a cromemaly tubing i can get the same strength out of a smaller cut. my idea is to mark out were the res hits and hole saw drill bit at that angel and fill it in with a piece of pipe at the same angel and flush it up so i don't louse to much metal.
it looks like ill only need to remove about a 1/2 to 3/4 of an inch but still need to mark it out mite be working on it this week end.
it looks like ill only need to remove about a 1/2 to 3/4 of an inch but still need to mark it out mite be working on it this week end.
